Paul and wall insulation technology

Foam, which has its own qualities, provides high thermal insulation in the house. The main ability is persistent endurance, it is able to withstand high mechanical overload. This gives a chance to participate in the construction. Polistyle foam in the last period is gaining popularization among construction companies. This material can act not only in the role of low -rise construction, but also as internal -derived isolation, as well as with monolithic construction. There is the possibility of using Polistyrene, which has a low density and does not change the load on the foundation over time, for the reconstruction of old brick, tile and wooden houses.

To the external turnover of the wall, plates (thermal insulation), are attached using mounting devices or glued. This material requires careful handling of it, admitting an open flame to what good will not lead. For such purposes, non-combustible mat-l: tiles, brick, steel or aluminum profile, etc.D. A wonderful effect is achieved when using foamplex for thermal insulation of walls (from the inside). In such cases, noise insulation qualities have been seen. The comfort in the room increases markedly. The thickness of the polystyrene foams on average ranges from 30 to 40 milimiters into the wall cavity, of course. These plates are easily attached, using the most ordinary wall anchors from 400 to 500 millimeters on a vertical surface and from 900 to 1000 on a horizontal surface.

There is another option, it consists in attaching these plates to the outer surface. Recommended values ​​when installing a thickness of 51 to 81 milimeter. The slabs in such cases are attached with adhesive compounds or standard mechanical mounts. In the same case, there will be no excess cladding. With internal installation, it will be required to cite drywall, or plaster with an external one: plaster with two cement layers of the solution, with application on a metal mesh.

The described plates described above is well warm and the floor of your housing. In this case, tiles made of polystyrene foam are laid on a layer of any material, with insulating properties. After sealing on top, a dumbfounded wood chips, concrete mixture with a thickness of 6 to 8 cm are laid on top.